These instructions are intended for qualified personnel who are 1. Notes on documentation familiar with the assembly, installation and operation of the ISYGLT system. It is essential that you read these operating instructions through before commissioning and keep them accessible for further 1.1.
Protect module from humidity • and configuration of the ISYGLT module may only be carried out by trained staff. In addition to these safety instructions, you must also observe the special safety instructions listed in the individual chapters for Observe the electrical installation regulations of the country in which the individual acts.
These are limited to the intended use of the module and refer EU on waste electrical and electronic equipment at the local collec- to the repair or replacement of the ISYGLT module. Please send the tion points for waste electrical and electronic equipment! device with an attached error description to our company address given below.
9. Product description The CC-03-USB has been developed for the implementation of small control tasks. On the hardware side there is a 0(1)-10V interface, a relay output in hybrid technology, 4 potentiometers, 8 low voltage button connections and 8 low voltage feedbacks, as well as 16 channels DMX-IN and 16 channels DMX-OUT.
230V 1500VA (max. 6.5A) with triac zero voltage switch Analog output 1 analog channel 8 bit resolution 0-10V (1-10V); output current max. 20mA (sink or source) Isolation voltage 1000V (ISYGLT BUS / analog outputs) Interface 1 RS-485 subnet BUS max. 5.6V limited by Z-diodes Interface 2 USB 2.0 Type-B socket for connection to PC / modem...
Page 7
Terminal Down right (front row) Terminal Down right (back row) +(E) +24V current-limited for inputs +(A) +24V current-limited for outputs Input 1 Output 1 Input 2 Output 2 Input 3 Output 3 Input 4 Output 4 Input 5 Output 5 Input 6 Output 6 Input 7...
Need help?
Do you have a question about the CC-03-USB and is the answer not in the manual?
Questions and answers