LG WM3998H A Series Owner's Manual page 32

32 OPERATION
WARNING
• Do not attempt to force the door to open when
locked. Doing so could result in damage to the
appliance, malfunction, or personal injury.
NOTE
• If the water level and temperature are safe, the
door lock LED turns off and the door unlocks
once the wash movement has stopped.
• If the water level is too high, the door will not
unlock, and this function cannot be used.
• If the temperature in the drum is higher than
113 °F (45 °C), a short warning chime sounds and
this function is not allowed for safety.
• This function is disabled during the Tub Clean
cycle.
• To preserve wash performance, wash time may
be extended depending on when garments are
added to a cycle.
• Be careful when opening the door as wet
laundry may drip or fall out.
TM
Turbo Wash
Adding this option reduces the cycle time while still
providing similar wash performance to the same
cycle without Turbo Wash
NOTE
• This option cannot be used with all cycles.
• This option defaults to on for Normal, Heavy
Duty and Perm.Press wash cycles.
Cold Wash
Press the Cold Wash button to save energy by
using cooler water. It will increase the wash and
rinse times to maintain wash performance.
• Wash time will increase up to several minutes
with this option.
• For best wash results, only wash small loads (less
than 8 lb) with this option.
Extra Rinse
This option adds an extra rinse to the selected
cycle. Use this option to help ensure the removal
of detergent or bleach residue from fabrics.
TM
.
• Press the Extra Rinse button to add additional
rinses to the cycle.
Rinse+Spin
Select this option to rinse and spin a load
separately from a regular cycle. This can be helpful
in preventing fresh stains from setting in fabrics.
1
Press the Power button to turn on the
washer.
• Do not select a cycle.
2
Press the Rinse+Spin button.
• You can change the spin speed by pressing
the Spin button.
3
Press the Start/Pause button.
Control Lock
Use this function to disable the controls. This
function can prevent children from changing
cycles or operating this washer.
NOTE
• The function does not lock the door.
• Once this function is set, all buttons are locked
except the Power button.
• When the controls are locked,
remaining time are alternately shown on the
display during the wash cycle.
• Turning off the power will not reset this function.
You must deactivate this function before you can
access any other options and functions.
Locking/Unlocking the Control Panel
1
Turn on the power.
2
Press and hold the Rinse+Spin button for 3
seconds to activate/deactivate this function.
• When the function is deactivated, a chime will
sound and the remaining time for the current
cycle will reappear on the display.
and the
CL