BUFF HUB Quick Start Manual

The HUB remote will function as a standard trigger, similar to our CyberSync Trigger
Transmitter, and provides all of the necessary communication between any camera
brand and a Paul C. Buff, Inc. flash unit. To utilize the TTL and HSS capabilities
of a Paul C. Buff, Inc. flash unit that is equipped with those features (i.e. the LINK),
a camera specific version of the HUB will be required.
ATTACHING THE HUB TO YOUR CAMERA
Slide the bottom of the HUB onto your camera's hot shoe.
Turn the locking wheel clockwise to lock the HUB on to your camera.
CHARGING THE HUB
4"
To charge the HUB plug the USB-C side of the included charging
cable directly into the HUB. Then plug the USB-A side into a wall
outlet connector.
FCC ID: OUEPCBHUB
FCC COMPLIANCE STATEMENT:
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause harmful interference
to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
WHAT'S INCLUDED:
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which
(1) HUB Wireless Remote
the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
(1) USB-A to USB-C Charging Cable
(1) Rechargeable Internal Lithium-ion Battery Warning: Changes or modifications to this unit not expressly approved by the part
responsible for compliance could void the user's authority to operate the equipment.
2-Year Factory Warranty
FCC Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirement.
info@paulcbuff.com | 1.800.443.5542 The device can be used in portable exposure condition without restriction.
12"
QUICK START GUIDE
WIRELESS REMOTE
INDICATORS - DO NOT PRINT
CROP MARKS
FINAL SIZE
FOLD
EXTERIOR