Advertisement
Quick Links
Advertisement
Related Manuals for BUFF HUB
Summary of Contents for BUFF HUB
- Page 1 QUICK START GUIDE WIRELESS REMOTE...
-
Page 2: What's Included
Paul C. Buff, Inc. flash unit. To utilize the TTL and HSS capabilities of a Paul C. Buff, Inc. flash unit that is equipped with those features (i.e. the LINK), a camera specific version of the HUB will be required. - Page 3 POWER BUTTON SYNC JACK REAR DISPLAY ROTARY WHEEL LOCKING BOTTOM HOT SHOE (CAMERA BRAND SPECIFIC) TOP HOT SHOE POWERING THE HUB ON / OFF Press and hold the POWER button, located on the right side of the HUB, for two seconds.
-
Page 4: Setting The Frequency
SENDING A TEST FIRE Press in on the rotary wheel, located on the left side of the HUB. This will send a test fire to any flash units that are on the same frequency. FREQUENCY TTL/MAN and HSS BATTERY INDICATOR... -
Page 5: Ttl Mode
ABOUT To access the serial number, current firmware version, and FCC ID within the HUB interface, first turn on the HUB and use the rotary dial to scroll to the ‘ABOUT’ section. Then, once ‘ABOUT’ appears on the display, press in on the rotary dial to enter the section. Finally, scroll using the... - Page 6 FCC ID: OUEPCBHUB FCC COMPLIANCE STATEMENT: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.