Related Manuals for Ikon PEAK 05
Summary of Contents for Ikon PEAK 05
- Page 2 Estimate on 75kg Rider WARNING: These are guidelines only. To waive any and all claims that you have or may in the future have against IKON Kiteboarding, resulting from use of this product and any of its components. KITE SIZE...
- Page 3 2. WARRANTY POLICY 3. BAR PRESENTATION The warranty on Ikon products is only valid to the original purchaser of the kite from one A 45cm Water bar is recommended for the Peak 5/7/9/10 and Blind 7/9. A 52cm of our official retailer or through Ikon website.
- Page 4 Safety 1 : Adjust the trim using cleat adjustment. Trim initial position is in full power. you are in a dangerous situation. When you use your IKON kite, for the first time, try the Pulling the depower handle towards you will reduce the power, you just have to lock it in release system.
- Page 5 3. BAR PRESENTATION 3. BAR PRESENTATION 3.4 Chose your safety - 4 Lines both front line - 4 Lines one front lines -5 Lines 3.4 Chose your safety - 4 Lines both front line - 4 Lines one front lines -5 Lines Otpion 01 : 4 Lines - safety on both front lines (factroy settings) Otpion 02 : 4 Lines - safety on one front line (recommended for the BLIND) From the factory settings :...
- Page 6 KITE SIZE 5TH LINE LENGTH 7 - Re-connect the safety line to the ring and PEAK 05 tread back through the velcro at the back of PEAK 07 the cleat, the bar and the chicken loop and PEAK 09 reconnect the ring of the chicken loop.
- Page 7 4. KITE PRESENTATION 4. KITE PRESENTATION 4.1 Kite setup 4.3 Launch & Land Securing your kite on land: To launch and land your kite, use an assistant on the edge of the wind window as you Layout your kite with bridles system facing up and wingtip facing into the wind, bladers teached with a profesionnal instructor.
- Page 8 4. KITE PRESENTATION 5. Care & Maintenance Gear 4.5 Pack 5.1 Bar 1. Secure your kite on the land with sand on top. The leading edge must face the wind. To open the quick release follow steps 1 through 8. To reassemble, follow the steps in Then wrap your lines back onto the bar in a figure 8 reverse and make sure to inspect all parts for damage and rinse the parts in fresh clean water before reassembly.
- Page 9 RIDE DIFFERENT...
Need help?
Do you have a question about the PEAK 05 and is the answer not in the manual?
Questions and answers