Contact information...8 Last modified: 05/03/18 Introduction The Honeywell WiFi thermostats are a series of WiFi thermostats that have been tested and certified for integration with the ClareHome system. When integrating a Honeywell WiFi thermostat into your ClareHome project, no extra connections are necessary. Install the thermostat according to the Honeywell documentation, register the thermostat on the Honeywell portal, enable auto mode in the thermostat, and then connect it to the network using IP.
The Following figure shows the Honeywell controls on the ClareHome UI. Figure 1: User interface of the Honeywell WiFi thermostat. (1) Change the Heat set point by sliding the indicator around the dial. (2) Change the Cool set point by sliding the indicator around the dial.
Registering the thermostat After installation, you must register the thermostat on the Honeywell portal. This allows the thermostat to be accessed remotely and updated with information from the Honeywell portal To register the Honeywell thermostat: To register your Honeywell WiFi devices, you must have each device’s Note: MAC ID and Device CRC.
1. Click the Devices tab, and then click the New Device button to display the Select Template dialog. 2. Expand the Climate folder, and browse to the Honeywell WiFi Thermostats. Climate > IP Thermostats > Honeywell WiFi Thermostats Doc ID - 1188 • Rev 04...
Page 5
1, the second thermostat is 2, and so on. • Device Name: The thermostats name in the Honeywell WiFi portal. Note: The names in the Honeywell portal and Fusion must be identical or the thermostat will not connect. The names are case sensitive.
7. Click the Save button 8. The Create Service dialog displays. Click OK, and the service is automatically created for you. Note: You can select Open Wizard to check or change the controls points as needed. 9. Configure rules to work with your thermostat. Configuring rules with TCC thermostats Configure a rule for your thermostat.
Page 7
4. Configure the Event Part as below. • Event Type: Device Property Change Event Note: This event type is replacing the Device Property Value Event. • Device: Honeywell WiFi thermostat • Function: Heat Cool Temperature Actuator • Property: Unit • Constraint: >...