Registering The Thermostat; Enabling Auto Mode - Honeywell TH9320WF Integration Release Notes

Registering the thermostat

After installation, you must register the thermostat on the Honeywell portal. This
allows the thermostat to be accessed remotely and updated with information from
the Honeywell portal
To register the Honeywell thermostat:
To register your Honeywell WiFi devices, you must have each device's
Note:
MAC ID and Device CRC.
1. Access the Honeywell WiFi portal at
https://mytotalconnectcomfort.com/portal.
2. Log into the website.
– or –
Create an account, and then log in.
3. Add a location.
Adding the location launches a registration wizard.
4. Complete the wizard to register your devices.
Note: You will need the thermostats name for Fusion. The name is case
sensitive and must match the name in Honeywell.

Enabling auto mode

For auto mode to function in the Clare Controls App, auto mode must be enabled
on the thermostat. This process varies by thermostat. Below are some examples.
Note: It is necessary to enable auto mode when its used with the Clare Controls
App.
To enable auto mode in the Honeywell 8321:
1. Disconnect the thermostat from the wall mount to view the back.
2. Note the pin code, and then connect the thermostat to the mount.
3. Press Menu, and then press the down arrow until the Installer Options
displays.
4. Tap Select and enter the pin code as prompted.
5. Press Done to view the Installer Menu, and then press the down arrow until
the Installer Setup displays.
6. Press Select, and then press Next until the System Changeover displays.
7. Toggle the System Changeover to automatic, and then press Done.
8. Tap Yes to exit the menu.
Doc ID - 1188 • Rev 04
3 / 8