Citizen CT-S310 User Manual page 11

PRECAUTIONS IN HANDLING THE PRINTER
Please observe the following precautions for power source and power cord:
Do not plug or unplug the power cord with a wet hand.
Use the printer only at the specified supply voltage and frequency.
Use only the specified AC adapter with the printer.
Use the power cord supplied with the product. Never use the power cord for other
product.
Check to make sure that the supply outlet from which the printer is powered has
a sufficient capacity.
Do not supply the printer from a power strip or current tap shared with other
appliances.
Do not plug the power cord into a supply outlet with dust or debris left on its
plug.
Do not use a deformed or damaged power cord.
Do not move the printer while the printer power is on.
• Neglecting to handle properly may result in printer failure, emission of smoke,
fire, or electric shock.
• An overload may cause the power cord to overheat or fire or the circuit breaker to
trip.
Do not allow anything to rest on the power cord. Do not place the printer where
the power cord will be trampled on.
Do not use or carry the printer with its power cord bent, twisted, or pulled.
Do not attempt to modify the power cord unnecessarily.
Do not lay the power cord in the neighbor of a heating device.
• Neglecting these cautions may cause wires or insulation to break, which could
result in leakage, electric shock, or printer failure. If a power cord sustains damage
contact your CITIZEN SYSTEMS dealer.
Do not leave things around the supply outlet.
Supply power to the printer form a convenient wall outlet, readily accessible in
an emergency.
• The printer may not be immediately shut down in an emergency.
Insert the power plug fully into the outlet.
If the printer is not to be used for a long time, leave it disconnected from its
supply outlet.
Hold the plug and connector when plugging or unplugging the power cord or
signal cable after turning off the printer and the appliance connected to it.
WARNING
— 6 —