Table of Contents
Advertisement
MEK-1001
7. Detailed View
1.
POWER:
2.
TRIG:
3.
A_WUP:
4.
D_LD:
5.
D_LD2:
6.
BZ1:
7.
F1:
8.
U2:
9.
U3:
10. CN1:
11. CN2:
12. CN3:
13. CN5:
14. CN6:
15. LED1:
16. LED2:
17. LED3:
Test Point:
Figure 1: Detailed View of MEK-1001
Power switch to activate or deactivate the device.
Trigger switch to start the scanning operation
Aiming and wake-up switch
Maintenance-mode switch to carry out the maintenance of a scan engine.
Second maintenance-mode switch
Buzzer which sounds at the completion of successful scan. For some scan
engines, this buzzer sounds when starting up the scan engine or when
changing the configurations of the scan engine.
Fuse (0.63A)
RS-232C driver
3.3V DC converter
Connector for MDI-1000 series scan engines (30-pin)
Connector for MDI-2000 series scan engines (12-pin)
10-pin RS-232C modular jack
Connector for MDI-2300 series scan engines (14-pin)
Connector for MDL-1000 and MDL-2000 series scan engines (17-pin)
(GR) Good Read LED lights in case of a successful scan. (MDL scan
engines do not support this LED.)
(SLEEP) Power down LED
(EX) External illumination LED lights
from the scan engine.
Orange colored ellipses
TS07004
synchronously to the control signal
7
Advertisement
Table of Contents
