Advertisement
Connected Sensor ST8 Gen2
Operation button functions
a) Pairing tubes and sensor
b) Pairing completion
c) Test mode
33)
d) Lamp off mode
e) Reset network
with master sensor
f) Remove slave sensor
from the network
Hereby, LEDVANCE GmbH declares that the radio equipment is in compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available at the following internet address:
WWW.LEDVANCE.COM/CONSUMER/SMART/DECLARATION-OF-CONFORMITY/INDEX.JSP
Wireless radio used in Zigbee lamps/luminaires/components 2400 – 2483.5 MHz, max. RF output
47)
power 9.5dBm.
Product needs to be mounted on the ceiling for full functionality. A vertical position is not allowed.
Do not operate sensor if it is damaged. Then the whole sensor must be replaced immediately.
7
25)
28)
31)
37)
40)
43)
26)
Action
Press operation button
on master sensor
29)
for 4 sec.
Press operation button
on any sensor
34)
2 times shortly
Press 4 times shortly
Press operation button
on master sensor
41)
10 times shortly
Press operation button
on slave sensor
44)
10 times shortly
27)
Impact
Green LED
starts blinking
Green LED
will turn off
Paired tubes and
sensors will start
blinking constantly
Paired tubes and
sensors will stop
36)
blinking
Lamp off mode
38)
will be activated;
see fig 17b
All devices will be set
to factory settings and
the whole network will
be unpaired
Slave sensor will be
set back to factory
settings; red light is
permanently on
30)
32)
35)
39)
42)
45)
46)
48)
Advertisement
