STA-RITE Calypso Owner's Manual page 5

• During operation of the Calypso, the recommended
suction level through the cleaner is indicated when the
base of the sliding cylinder aligns with or moves into
the yellow area. If the yellow band is completely cov-
ered, you may have excessive suction.
• We will come back to this when optimizing your
cleaner's performance.
Now fit the female end of the regulator valve to the male
end of the hose.
Set aside the regulator valve cover for now.
Yellow Band
Figure 7
Figure 8
Figure 9
Side Opening
5
Step 5: Attach the hose and cleaner to the filter sys-
tem (Figure 10).
Stop the pool filtration pump. Place the Calypso in the
pool and allow it to sink to the bottom, pulling the at-
tached hose with it. Continue to feed the hose into the
water until all air is expelled and you are left holding the
regulator end of the hose.
Hazardous suction. Can trap hair or body
and cause death or serious injury. Make sure that your
dedicated wall fitting has a spring-loaded lid. When at-
taching the cleaner hose to a dedicated wall fitting, al-
ways install the regulator valve cover on the regulator
valve first and then install the assembled hose, valve, and
cover in the wall fitting. This will help prevent possible in-
jury from the pool pump's suction should the hose be-
come detached from the regulator valve.
Figure 10