Raider RD-WL03 User Manual page 11

11
4. Place the "V" –looking belt in the correct position. Pre-selected speed according to specifics of the
job.
5. Tighten the belt. It must be tensioned to move no more than 1 cm.
SETTING THE OPERATING UNITS
Movement of the clamp (5) and right holder (7)
Movement of operating parts shall be carried out by rail guides. To make adjustment is necessary:
1. Unplug the appliance power cord;
2. Place the piece that will handle, remove the operating parts and tighten by 4 bolts.
3. To set up the right holder will have to remove the handle with protective plate (see diagram below):
4. BASIC WORK ELEMENTS
These instructions will help you with the basic operations when working with RD-WL03T.
Attention! Always keep your hands away from moving parts!
1. Choose a suitable piece of wood;
2. Draw diagonal lines on it to determine the center (see diagram below):
3. After you define the center, do gentle circular hole with knife. This will make a "bed" of the holder;
5. Make a hole on the other side of wood piece, by using the center and a rubber hammer (see chart
below)
6. Place the tree in the specified way and go to treatment.