Specifications - Cisco SGE2000 Datasheet

© 2008-2009 Cisco Systems, Inc. All rights reserved. This document is Cisco Public Information.
Simplified QoS management using 802.1p, differentiated services (DiffServ), or (ToS) traffic
●
prioritization specifications
Power redundancy when used with Cisco RPS1000 380W Redundant Power Supply Unit
●
Fully resilient stacking for optimized growth with simplified management
●
ACLs for granular security and QoS implementation
●
Can be configured and monitored from a standard web browser
●
Secure remote management of the switch via Secure Shell (SSH) and SSL encryption
●
802.1Q-based VLANs enable segmentation of networks for improved performance and
●
security
Private VLAN Edge (PVE) for simplified network isolation of guest connections or
●
autonomous networks
Automatic configuration of VLANs across multiple switches through Generic VLAN
●
Registration Protocol (GVRP) and Generic Attribute Registration Protocol (GARP)
User/network port-level security via 802.1X authentication and MAC-based filtering
●
Increased bandwidth and added link redundancy with link aggregation
●
Enhanced rate-limiting capabilities, including back pressure, multicast, and broadcast flood
●
control
Port mirroring for noninvasive monitoring of switch traffic
●
Jumbo frame support up to 10KB
●
Simple Network Management Protocol (SNMP) versions 1, 2c, and 3 and Remote
●
Monitoring (RMON) support
Fully rack mountable using the included rack-mounting hardware
●
Simple, one-step automated installation and initial configuration
●

Specifications

Table 1 contains the specifications, package contents, and minimum requirements for the Cisco
SGE2000 24-Port Gigabit Switch.
Table 1. Specifications for the Cisco SGE2000 24-Port Gigabit Switch
Specifications
Ports
Buttons
Cabling type
LEDs
Performance
Switching capacity
Forwarding rate
(based on 64-byte packets)
Stacking
● 24 RJ-45 connectors for 10BASE-T/100BASE-TX/1000BASE-T with 4 shared Gigabit
SFP slots
● Console port
● Auto medium dependent interface (MDI) and MDI crossover (MDI-X)
● Auto negotiate/manual setting
● RPS port for connecting to redundant power supply unit
Reset button
● Unshielded twisted pair (UTP) Category 5 or better for 10BASE-T/100BASE-TX
● UTP Category 5 Ethernet or better for 1000BASE-T
PWR, Fan, Link/Act, Speed, RPS, Master, Stack ID 1 through 8
Up to 48 Gbps, nonblocking
Up to 35.7 mpps
Data Sheet
Page 2 of 5