Advertisement
Documentation Center
EU433
CN470
CN470ALI
RU864
IN865
EU868
US915
AU915
KR920
AS923
For this demonstration, EU868 shall be used. To set the desired regional frequency band use the command:
AT+REGION=EU868
NOTE
The regional frequency settings need to be consistent with the RAK commercial gateway supported band.
Data Serial Port Rate Setting
NOTE
The baud rate setting needs to be consistent with the baud rate of the sensor, which is 9600.
The AT command for execution is:
AT+BAUDRATE=9600
Operating and Activation Mode Settings
1. Supported operating modes are two: Class A and Class C. To set the operating mode (Class C in this case),
you need to execute the AT command:
AT+CLASS=C
NOTE
The changes take effect as soon as they are made.
2. Activation mode supports the following two modes: ABP and OTAA. To set the activation mode (OTAA in this
case), you need to execute the AT command:
AT+JOINMODE=OTAA
sh
sh
sh
sh
Advertisement
