Advertisement
USING YOUR MACHINE
IMPORTANT: Test all carpets/rugs/upholstery/hard floors before use. Before using the machine to clean dried on stains and
dirt, the surface should be vacuumed thoroughly.
Test for colourfastness - Wet a white absorbent cloth with the solution. In a small hidden area of the surfaces to be cleaned,
gently rub with the dampened cloth. Wait ten minutes and check for colour removal or bleed with a white paper towel or cloth.
Check all surfaces to be cleaned and if the surface has more than one colour, check all colours.
Test the spot washer on a small hidden area - If no damage or pile distortion occurs continue cleaning.
Move furniture out of the area to be cleaned. If the furniture cannot be moved, place aluminium foil or wax paper under
the legs. This will prevent wood finishes from staining your carpet. Pin up furniture skirts and curtains.
When using the spot washer, basic safety precautions should always be observed and don't over saturate your carpets/
rugs/upholstery/hard floors.
Only use with VAX Spot Washer Cleaning Solution or VAX Spot Washer Antibacterial Cleaning Solution. Using other solutions
may cause excess foaming and will invalidate your guarantee.
The clean water/solution tank should only be filled with warm water (max 40⁰C). Filling the clean water/solution tank with
hot/boiling water will damage your spot washer and invalidate the guarantee.
Filling the clean water/solution tank
Press the clean water/
solution tank release
button. Pull and lift to
remove the tank.
Screw the cap back onto
the clean water/solution
tank.
Unscrew the cap out of
the clean water/solution
tank.
Refit the clean water/
solution tank onto the
machine so it clicks
into place.
40°C
MAX
Fill the tank with warm
water (max 40°C) and
solution to the desired clean
level, indicated by the lines
on the tank, or as follows:
Large area clean
1L of water with
250ml solution.
Small area clean
500ml of water with
125ml solution.
9
Hide quick links:
Advertisement
