Removing And Installing A Layer 3 Services Module - Cisco Catalyst X4232 Installation And Configuration Note

Removing and Installing a Layer 3 Services Module

Varoitus Kun porttiin ei ole kytketty kaapelia, portin aukosta voi vuotaa näkymätöntä
lasersäteilyä. Älä katso avoimiin aukkoihin, jotta et altistu säteilylle.
Attention Etant donné qu'un rayonnement laser invisible peut être émis par l'ouverture du port
quand aucun câble n'est connecté, ne pas regarder dans les ouvertures béantes afin
d'éviter tout risque d'exposition au rayonnement laser.
Warnung Aus der Öffnung des Ports kann unsichtbare Laserstrahlung austreten, wenn kein
Kabel angeschlossen ist. Kontakt mit Laserstrahlung vermeiden und nicht in offene
Öffnungen blicken.
Avvertenza Poiché quando nessun cavo è collegato alla porta, da quest'ultima potrebbe essere
emessa radiazione laser invisibile, evitare l'esposizione a tale radiazione e non
fissare con gli occhi porte a cui non siano collegati cavi.
Advarsel Usynlige laserstråler kan sendes ut fra åpningen på utgangen når ingen kabel er
tilkoblet. Unngå utsettelse for laserstråling og se ikke inn i åpninger som ikke er
tildekket.
Aviso Evite uma exposição à radiação laser e não olhe através de aberturas expostas,
porque poderá ocorrer emissão de radiação laser invisível a partir da abertura da
porta, quando não estiver qualquer cabo conectado.
¡Advertencia! Cuando no esté conectado ningún cable, pueden emitirse radiaciones láser invisibles
por el orificio del puerto. Evitar la exposición a radiaciones láser y no mirar fijamente
los orificios abiertos.
Varning! Osynliga laserstrålar kan sändas ut från öppningen i porten när ingen kabel är
ansluten. Undvik exponering för laserstrålning och titta inte in i ej täckta öppningar.
Removing and Installing a Layer 3 Services Module
The following sections describe how to remove and install modules, GBICs, and cables:
•
•
•
•
•
Catalyst 4003 and 4006 switches support hot swapping, which lets you install, remove, replace, and
rearrange modules without turning off the system power. When the system detects that a module has
been installed or removed, it runs diagnostic and discovery routines automatically, acknowledges the
presence or absence of the module, and resumes system operation with no operator intervention.
Warning Only trained and qualified personnel should install, replace, or service this equipment.
Installation and Configuration Note for the Catalyst 4000 Layer 3 Services Module
20
Required Tools, page 21
Removing Modules, page 21
Installing the Layer 3 Services Module, page 22
Installing a GBIC, page 24
Attaching Interface Cables to the Layer 3 Services Module, page 26
78-10164-03