Advertisement
OPERATING MANUAL
Infrared thermometer
FlashBeam 8869
Safety
•
Use extreme caution when the laser beam is turned on.
•
Do not let the beam enter your eye, another person's eye or the eye of an animal.
•
Be careful not to let the beam on a reflective surface strike your eye.
•
Do not allow the laser light beam impinge on any gas which can explode.
Operating elements
LCD display
Power ON/OFF
°C / °F
selecting temperature units
Laser pointer
Backlite LCD
1.1.
Operation
Operating element
Power ON/OFF
Selecting Temperature units
(°C/°F)
Data Hold
Backlite LCD
Laser Pointer
Measurement Considerations
Holding the meter by its handle, point the IR Sensor toward the object whose temperature is to be measured.
The meter automatically compensates for temperature deviations from ambient temperature. Keep in mind that it will take up to 30
minutes to adjust to wide ambient temperature changes.
When low temperatures are to be measured followed by high temperature measurements, some time (several minutes) is required
after the low (and before the high) temperature measurements are made. This is a result of the cooling process which must take
place for the IR sensor
Technical changes reserved
0141 0315-20
10/2010
Description
The meter automatically powers when the ON/HOLD key is pressed. Press the MEASURE key to
take a reading. Read the measured temperature on the LCD. The meter powers OFF
automatically approximately 5 seconds after the ON/HOLD key is released.
Select temperature units (degrees C or F) by first pressing the ON/HOLD key and then pressing
the °C/°F key. The units will blink on the LCD. Press the °C/°F key until the desired units are
shown on the LCD.
This meter automatically holds the last temperature reading on the LCD for five seconds after the
ON/HOLD key is released. No extra key presses are necessary to freeze the displayed reading.
Select backlite by first pressing the ON/HOLD key and then pressing the BACKLITE key. Repeat
the procedure to turn the backlight OFF.
To turn the laser pointer ON, press the LASER key while pressing the ON/HOLD key. Repeat the
procedure to turn the laser OFF.
B+B Thermo-Technik GmbH | Heinrich-Hertz-Str. 4 | D-78166 Donaueschingen
Fon +49 771 83160 | Fax +49 771 831650 | info@bb-sensors.com | bb-sensors.com
Laser pointer
2 / 3
Advertisement
