Cisco 7201 Quick Start Manual page 24

Figure 22 Placing the Ground Lugs, Star Washers, and Nut
Place the ground lugs, star washers, and nut on the grounding stud in this order:
Step 6
a. Star washer
b. Ground lug
c. Star washer
d. Ground lug
e. Nut
Tighten the nut to complete the installation.
Step 7
Attach the other end of the ground wires to an appropriate grounding point at your site.
Step 8
Repeat Step 1 through Step 8 on the second DC power supply.
Step 9
Wire the DC-Input Power Source
The color coding of the DC-input power supply leads depends on the color coding of the DC power source at your site.
Note
Make certain the lead color coding you choose for the DC-input power supply matches lead color coding used at the
DC power source.
Warning When installing or replacing the unit, the ground connection must always be made first and disconnected last.
Statement 1046
Warning This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than: 120 VAC, 20A U.S. (240 VAC, 10A international). Statement 1005
Warning Before performing any of the following procedures, ensure that power is removed from the DC circuit.
Statement 1003
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Statement 1030
24