Makita BSS611 Technical Information page 3

R
epair
[3] Replacing Base complete (cont.)
2. Remove the following parts as shown in Fig.4.
Base complete can be separated from the machine.
A) Shoulder pin 6-7 for connecting Angular guide and
Base complete
B) Stop ring E-8, M6 Hex nut, Flat washer 6 and M6x20
Cap square neck bolt for securing Lever 30
3. Reuse the above parts (for example, Mx6 Hex socket
head screws) to replace the current base complete by
the new one.
Note: M6 Hex nut in Lever 30 is not interchangeable with
M6 Hex nut in Lever 40.
The former has left handed threads, the latter has
right handed threads.
[4] Assembling Lock Off Lever and Switch Lever
1. Compression spring 4 for Lock off lever and Compression spring 4 for switch lever are the same.
Insert the bosses of Lock off lever and Switch lever into the compression springs 4 as illustrated in Fig.5.
2. Put their assembled parts into places as illustrated in Fig.6 so that the Compression springs 4 can perform well between
the bosses and the Ribs of Housing L.
Fig.5
Lock off lever
Boss
Compression spring 4
Boss
Switch lever
[5] Disassembling/Asssembling Safety Cover and Bearing Box
DISASSEMBLING
1. Remove Rubber ring 6 together with M6 countersunk head screw as illustrated in Fig.7.
2. Remove retaining ring S-34 with No.1R003. Safety cover can be separated from the machine as illustrated in Fig.8.
3. Remove Bearing box by unscrewing two M5x16 countersunk head screws as shown in Fig.9. If it is difficult to remove
the Bearing box by hand, lever it up with 1R263 as shown in Fig.10.
Fig.7
Countersunk
head screw M6
Rubber ring 6
Fig.9
M5x16 Countersunk
head screw (2 pcs.)
Fig. 4
Lever 30
Stop ring E-8
Fig.6
Fig.8
Retaining ring
Safety cover
(EXT) S-34
Fig.10
Bearing box
M6x20 Cap square neck bolt
Flat washer 6
M6 Hex nut
Angular guide
Rib
Switch
Compression spring 4
1R263 Bearing extractor
P 3/ 6
Hex wrench
Shoulder pin 6-7
M5x6 Hex socket
head set screw
Housing L
Lock off lever
Rib
Switch lever
Safety cover