Cisco 1711 Datasheet page 7

Table 2 Part Numbers
Part Number Description
CISCO1711-VPN/K9 Security access router with integrated
4-port switch, 10/100BASE-TX for WAN and
analog modem backup
CISCO1712-VPN/K9 Security access router with integrated
4-port switch, 10/100BASE-TX for WAN and
ISDN S/T backup
Physical Interfaces/Ports
Four 10/100BASE-TX autosensing Fast Ethernet switched ports
• RJ-45 jacks
• MDI/MDIX autocrossover
• Full-/half-duplex
• IEEE 802.1Q VLAN routing (16 VLANs)
• Spanning Tree Protocol 802.1D
One ISDN BRI port on the Cisco 1712 Router
• ISDN dialup and ISDN DSL (IDSL) at 64 and 128 Kbps
• Encapsulation over IDSL, Frame Relay, and PPP
• ISDN WAN port features are consistent with Cisco 1-port ISDN
WAN interface card (WIC-1B-S/T)
One analog modem port on the Cisco 1711 Router
• RJ-11 jack
• Support for speeds up to 56 Kbps (V.90)
• Separate RJ-11 jack for telephone connection
• Point-to-Point Protocol (PPP), Multilink PPP (MLPPP), and
Serial Line Internet Protocol (SLIP)
One 10/100BASE-TX Fast Ethernet WAN port (RJ-45)
• Automatic speed detection
• Automatic duplex negotiation
One auxiliary port
• RJ-45 jack with EIA/TIA-232 interface
• Asynchronous serial data rates up to 115.2 Kbps
One console port
• RJ-45 jack with EIA/TIA-232 interface
• Transmit/receive rates up to 115.2 Kbps (default 9600 bps, not
a network data port)
Performance Summary
• Firewall and IDS throughput: 20 Mbps
• 168-bit 3DES IPSec VPN throughput: 15 Mbps
• 128-bit AES IPSec VPN throughput: 4.5 Mbps
• Simultaneous VPN peers: 100
All contents are Copyright © 1992–2003 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
Memory
Flash memory
• Default: 32 MB
• Maximum: 32 MB
DRAM memory
• Default: 64 MB
• Maximum: 128 MB
Dimensions and Weight
• Width: 11.2 in. (28.4 cm)
• Height: 3.1 in. (7.85 cm)
• Depth: 8.7 in. (22.1 cm)
• Weight: 2.9 lb (1.32 kg)
Power
• AC input voltage: 100 to 240 VAC
• Frequency: 47 to 64 Hz
• AC input current: 0.5 A
• Power dissipation: 20W (maximum)
Environmental
• Operating temperature: 32 to 104 F (0 to 40 C)
• Nonoperating temperature: -4 to 149 F (-20 to 65 C)
• Relative humidity: 10 to 85 percent noncondensing operating; 5
to 95 percent noncondensing, nonoperating
Safety
Certifications
• UL 1950
• CSA 22.2—No. 950
• EN60950
• EN41003
• AUSTEL TS001
• AS/NZS 3260
• ETSI 300-047
• BS 6301 (power supply)
EMI
Classifications
• AS/NRZ 3548 Class A
• FCC Part 15 Class B
• EN60555-2 Class B
• EN55022 Class B
• VCCI Class II
• CISPR-22 Class B
Cisco Systems, Inc.
Page 7 of 8