Quick Reference To Controls; Quick Reference To Display; Set The Clock; System Switch - Honeywell Home PRO 2000 Series Operating Manual

PRO 2000 SERIES

QUICK REFERENCE TO CONTROLS

Press to set clock, day or schedule (see
page 2.
Press to override schedule and hold
temperature (see page 3).
Press to run (follow) schedule (see
page 3).

QUICK REFERENCE TO DISPLAY

Temporary schedule
override (see page 11)
Setpoint indicator
Appears when the setpoint
temperature is displayed.
Low-battery warning
(see page 4)
Permanent schedule override
(see page 4)
Schedule period
* When Heat On or Cool On is flashing, compressor protection is engaged (see page 4).
** Applies to TH2210D model only.

SET THE CLOCK

Set Time
1. Press the Set button. Set Time will appear on the
screen and the time display will flash.
2. Press the or button to set the time.
3. Press the Set button again. Set Day will flash on the
screen.
4. Press the or button to select the day of the
week.
5. Press the Run button to save the changes & exit.
(The changes are also saved if you do not press any
button for 60 seconds.)
NOTE: The clock has lost its settings when the time dis-
play flashes. If the thermostat is following the
schedule, it will use the temperature settings pro-
grammed for the Wake period of the weekdays
until you readjust the clock.
69-1969EFS—09
Press to adjust
temperature
Set Day
Fig. 3.
Screen
Lit for 12 seconds when you press any button.
Fan Switch (see page 3)
• On: Fan runs all the time.
• Auto: Fan runs only when heating or cooling is taking place.
System switch (see page 2)
• Cool: System is in Cooling mode.
• Off: System is off.
• Heat: System is in Heating mode.
• Em Heat: System is in Emergency Heat mode.
Fig. 1.
Clock
Temperature
The ambient (measured) temperature is normally
displayed. To view the setpoint temperature,
press either of the temperature adjustment
buttons once. The setpoint temperature will
appear for five seconds.
System status
• Cool On: Cooling is activated. *
• Heat On: Heating is activated. *
• Aux On: Auxiliary heat is activated. **
Fig. 2.

SYSTEM SWITCH

Use the System switch to place the system in one of the
following modes:
• Cool: System is in Cooling mode.
• Off: System is off.
• Heat: System is in Heating mode.
• Em Heat: System is in Emergency Heat mode. Only
auxiliary heating can be activated. The compressor is
disabled. (This mode is available on the TH2210D
model only.)
CAUTION
EQUIPMENT DAMAGE HAZARD.
Do not use Cooling mode when the outdoor
temperature is below 50 °F (10 °C).
2
Fig. 4.