Factory Set; Weighing Unit - HiWeigh X1FM User Manual

Step Operation
1 Press *
Press →
2 Press *
3 Load max weight
Press *
4 Press →
Press ↑
Or →0←
5 Press *
§7. ADC Counts Display
Confirm load cell connect is correct to check ADC counts. After set the short pin, ADC counts should
around 100000-200000. After above setting, check ADC counts directly:
Step Operation
1 Press *
2 Press *
3 Press *
4 Press →
5 Press *
§8. Factory Set
Step Operation
1 Press *
2 Press *
3 Press *
4 Press *
5 Press →
Factory default: d=0.01 FS=150.00 FLt=2 AUtP=11 Adr=00 b=2400
§9. Weighing Unit
Step Operation
1 Press *
On
2 Press ↑
3 Press →
4 Press ↑
→0←
5 Press *
Displaying
CAL SP Indicator in calibration mode
CAL 00 Enter to set ZERO
------ Set ZERO
3000 After several seconds, indicator displays maximum weight
3000 Display weight
000000 If the weight is not the max weight, press
→0←
002000 e.g.: weight is 2000
------ Calibrate
2000 After several seconds, indicator displays weight, then finish
calibrate
Displaying
CAL SP Indicator in calibration mode
-SEt- Indicator in configuration mode
-A -d- ADC counts display
43125 Enter to check ADC counts, and display 43125
0 Return to weighing mode
Displaying
CAL SP Indicator in calibration mode
-SEt- Indicator in configuration mode
-A -d- Indicator in ADC counts display mode
FACt Select Back to factory set
0 Back to factory set and return to weighing mode
Displaying
000000 Press
999999 If it displays [UE=21.X], user can set own unit
0
2.0000 Select unit
000000 Digit flash
01.6535 Change digit number
If user unit is Hong Kong kg, enter 1.6535
HE 0 Decimal/H exadecimal (lb And UU)
0---Decimal
1--- Hexadecimal
Descriptions
to input actually weight
Descriptions
Descriptions
Descriptions
* and ON to switch on indicator
→ and ↑ or