Table of Contents
Advertisement
7. DISASSEMBLING
WARNING
•
Make sure to disconnect the power source before disassembling the unit.
•
Carefully disassemble the unit. Do not touch evaporator and condenser directly or you may cut or injure your
hands.
CAUTION
•
Do not touch the compressor, the discharge pipes, or any parts that may be subjected to high temperature,
before the temperature becomes low or with the use of protect gloves.
1. Remove two (2) screws
2. Removing eight (8) screws
remove the rear panel.
3. Remove three (3) screws
4. Remove three (3) screws
screw A from the left side of the front panel.
5. In this condition, you can remove the front panel and the right/left side panels simultaneously.
6. If it is necessary to remove the right/left side panels from the front panel, they can be removed by removing
two (2) screws
from the back of the unit.
G
7. If it is necessary to remove the indication lamp circuit F, remove five (5) screws
lamp circuit.
A
B
B
C
D
A
F
17
from the top plate I.
A
, two (2) screws
B
each from the back of the right/left side panels L, M.
E
from the right side of the front panel G. And remove two (2) screws F and one (1)
F
19
20
22
and two (2) screws
C
D
23
16
23
H
F
6
from the back of the rear panel J,
from under the indication
H
E
E
G
G
20
21
20
22
18
21
22
18
Advertisement
Table of Contents
