LG Cloud Device All-in-One Thin Client Safety And Regulatory Information Manual page 12

Caution
Do not install the ME Equipment in a location without easy disconnect accessibility.
Environment of Use and Storage
Do not install the monitor in a location with the conditions listed below.
Otherwise, it may result in failure or malfunction, cause fire or injury.
• Close to facilities where water is used.
• Where it will be exposed to direct sunlight.
• Close to air-conditioner or ventilation equipment.
• Close to heat source such as a heater.
• Prone to vibration
• Unsecure location place.
• Dusty environment.
• Saline or sulfurous environment.
• High temperature or humidity.
• Freezing or condensation.
Do not place the storage case in a location with the conditions listed below.
• Where the cable of the monitor unit will be strongly pulled when the monitor
is put into the case, otherwise, the cable may be damaged, resulting in fire or
electric shock.
• Where someone might get their foot caught in the cable of the monitor.
12
Handling
For safety reasons, be sure to turn off the power when monitor is not used.
MANUFACTURER will make available on request circuit diagrams, component part
lists, descriptions, calibration instructions, or other information that will assist
SERVICE PERSONNEL to repair those parts of ME EQUIPMENT.
Location of Cables
Make sure all cables are located so that they cannot be stepped on, tripped over, or
otherwise subjected to damage or stress.
If the monitor is defective, do not disassemble the monitor randomly. Maintenance
of the monitor should be done by a manufacturer.