Initial Installation; Viewing E-Manual; Troubleshooting - Sharp Aquos 2T-C32BG1X Initial Setup Manual

Initial installation

Follow the steps below one by one when using the TV for the fi rst time. Some steps may not be necessary
depending on your TV installation and connection.
2T-C42BG1X

Connect an antenna cable to the antenna terminal.

Plug the AC cord into the AC outlet.
Cable tie
Bundle the cables into
cable tie.
Press cable tie clip (1)
and pull out cable tie (2)
completely to release.
• Place the TV close to the AC outlet, and keep the power plug within
reach.
CAUTION
TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH
UN-INSULATED PARTS OF ANY CABLES WITH THE AC CORD
CONNECTED.
Initial Setup Guide_2T-C3242BG1X (HK)_H317.indb 13 Initial Setup Guide_2T-C3242BG1X (HK)_H317.indb 13

Press (JOG-KEY) on the TV.

Run the initial installation.
• Follow the guide on the TV
screen to set the following
settings.
■
Language setting
■
Country setting
■
Home/Retail setting
■
Pairing setting
■
Initial setup has fi nished

For Hong Kong DTV channel
setting.
■
'DTV-HK' input
■
Auto Search
■
Initial setup has fi nished
- 9
EN

Viewing E-Manual

Viewing the Built-in Operation Manual
Displays the built-in operation manual on the
screen. You can read information about how to use
this device.
1
Press (HOME) to display the HOME
screen, and then press / / / to select
"Settings".
Press / to select "Apps", press /
to select "Manual", and then press ENTER.
This displays the built-in operation manual
screen.
2
When you select contents, its page will be
displayed.
Appendix

Troubleshooting

The problems described below are not always caused by malfunctions. Check the TV again before having
the TV serviced.
Problem
• No power. • Check if you pressed POWER on the remote control unit.
• Is the AC cord disconnected?
• Has the power been turned on?
• Remote control unit does
• Are batteries inserted with polarity (e, f) aligned?
not operate.
• No picture. • Is connection to other components correct?
• No sound. • Is connection to other components correct?
CLEARING THE PASSWORD
If you forget the password, clear the password using the following procedure.
1
From the HOME screen, select "Settings" > "Device Preferences" > "Reset", and then press ENTER.
2
When you perform a reset, the TV will be returned to the factory preset values, and you need to set
the password again.
NOTE
• As a precautionary measure, make a note of your password, and keep it in a safe place.
- 10
EN
2
1
Possible Solution
29/6/2020 10:25:04 AM 29/6/2020 10:25:04 AM