Viavi T-BERD MTS-5800 Quick Card page 4

Trace view:
• Graphical results for each wavelength or pulse
width are shown in different colors in center
display. Tap 1 or 2 to select the wavelength or
pulse width for results display.
• Distance, Loss, and Reflectance for the first
event is listed in the lower display. Swipe up to
see additional events. Values that violate loss
or reflectance pass/fail thresholds are shown
in RED.
• Tap the magnifying glass icons to zoom in
zoom out , or auto-zoom
You can also pinch and zoom with your fingers.
SmartLink view:
• The Fiber under test is displayed as a series of
icons representing each event (connector, splice,
bend, etc.). If there are more than 4 events, swipe
left to display additional icons.
Note: the icon-based view is not available if
Acquisition Mode = SmartAcq.
• In the center display, view summary results per
wavelength or pulse width for the entire span.
Acquisitions for which all events are acceptable are
marked with a green check
events that exceed pass/fail thresholds for loss or
reflectance are marked with a red
• In the lower display, view each event that exceeds
thresholds.
• Tap on an event icon to the view detailed results
for the event.
Note: the icon-based view may not be available
on older T-BERD 5800s when acquisition Mode =
SmartAcq. Rerun the test with Manual or Auto
Acquisition or contact VIAVI to upgrade your unit
to add this feature.
,
the display.
. Acquisitions with
.
VIAVI Solutions
Figure 8: Trace view
Figure 9: SmartLink view
Figure 10: Event view