Table of Contents
Advertisement
About this task
The following image indicates the location of the power-button with optional fingerprint reader and provides a visual
representation of the installation procedure.
Steps
1. Using the alignment posts, place the power-button with optional fingerprint reader on the palm-rest and keyboard assembly.
2. Align the screw holes on the power-button with optional fingerprint reader to the screw holes on the palm-rest and keyboard
assembly.
3. Slide the power-button board under the securing clip.
4. Adhere the power-button cable to the palm-rest and keyboard assembly.
5. Replace the two screws (M2x2.5) that secure the power-button with optional fingerprint reader to the palm-rest and
keyboard assembly.
6. Place the power-button bracket on the power-button with optional fingerprint reader.
7. Align the screw hole on the power-button bracket to the screw hole on the palm-rest and keyboard assembly.
8. Replace the screw (M2x2) that secures the power-button bracket to the palm-rest and keyboard assembly.
Next steps
1. Install the
I/O
board.
2. Install the
display
assembly.
3. Install the fan.
4. Install the
base
cover.
5. Follow the procedure in
Touchpad
Removing the touchpad
Prerequisites
1. Follow the procedure in
2. Remove the
base
cover.
52
Removing and installing components
After working inside your
Before working inside your
computer.
computer.
Advertisement
Table of Contents
