Maintenance; Fcc Statement - Godo RING72 Instruction Manual

Macro led ring light
Table of Contents

Advertisement

Maintenance

• When the flash is working, if an abnormality is found, the power should
be turned off immediately to find out the cause.
• The lamp body should avoid vibration, and always pay attention to dust
removal on the surface.
• It is normal that the lamp body is slightly hot. Do not flash continuously
when there is no special need.
• All repairs are handled by the repair department designated by the
factory for original parts.
• One year warranty, consumables such as lamps are not covered by one
year warranty.
• All maintenance shall be handled by the maintenance department
designated by the factory.
• If this product breaks down or gets wet, it can be used only after
professional repairs.
• Subject to technical changes without notice.
- 17 -

FCC Statement

This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
- 18 -

Advertisement

Table of Contents
loading

Table of Contents