Wolf Steel NPI-45 Installation Instructions

Included in this kit:
ITEM # PART#
1 W263-0090
2 W263-0092
3 W263-0091
4 W715-0753
5 W715-0755
6 W715-0754
7 W080-0059
8 W385-0334
9 W160-0014
W570-0001
W570-0006
W570-0020
W735-0026
W450-0008
1. Secure the Right Flashing to the right side of the unit using two
of the #8 x 1/2" screws.
2. Remove the two control panel securing screws, discard the
screws and shipping bracket.
3. Secure the control
panel to the Right
Flashing using the
two #8 x 3/8" screws.
Secure the
(FIGURE 2)
Left Flashing with the
remaining #8 x 1/2"
screws.
NI800 FLASHING KIT
INSTALLATION INSTRUCTIONS
FOR MODEL NPI-45
DESCRIPTION
Top Flashing
Right Flashing
Left Flashing
Top Trim
Right Trim
Left Trim
Corner Bracket
Napoleon Logo
Spring clip
Screw, #8 x 3/8"
Screw, #8 x 1/2"
Screw, #8-32 x 3/8"
Lock Washer, #8
Nut, #8-32 Hex
(FIGURE 2)
FIGURE 1
SHIPPING CONTROL
BRACKET PANEL
FIGURE 2
SECURING SECURING
SCREWS SCREWS
QTY
1
1
3
1
1
1
1
2
6
1
9
2
4
8
4
4. Align the holes in
the top of the Right and
4
Left Flashing with those
4
on the bottom lip of the
Top Flashing and secure
from the rear using the
four #8-32 x 3/8" screws,
washers and
(FIGURE 3)
5. The three
pieces of trim
are assembled
in the same
manner as a
picture frame.
Place the corner brackets (with screw
loosened) into the trim sections. Tighten
the screw spreading the two pieces apart.
Attach the adjoining section. Repeat with
the opposite side. Tighten all screws
fi rmly.
(FIGURE 4)
6. Slide the assembled trim down over
the fl ashing.
(FIGURE 5)
CONTROL
PANEL
7. On the backside of
the trim, use 3 spring
RIGHT
clips per side to take
FLASHING
up the space and
tighten the fi t of the
trim.
8. Affi x the
logo to the
bottom left
hand corner
of the left
fashing.
4
1
nuts.
FIGURE 4
W415-0657 / C / 11.23.11
2
5
FIGURE 3
TOP
FLASHING
7
FIGURE 5
TRIM
ASSEMBLY