Advertisement
1. STOP
VERIFY ALL DIMENSIONS
TO ENSURE THAT THIS
PRINT IS 1 TO 1 SCALE.
MIN. FINISHED
CLEARANCE
ALTINEX, INC. IS NOT RESPONSIBLE
FOR ANY DAMAGE TO A TABLE OR DESK.
1. STOP
2. MEASURE
inch.
0"
1"
cm.
0
1
2
3
4
MEASURE WITH A RULER.
!
DO NOT DAMAGE OR THROW AWAY
THIS PORTION. THIS IS TOP COVER.
FINISHED CUT-OUT
DIMENSION
FRONT
DO NOT SCALE OR ADJUST!
R
2. MEASURE
2"
3"
5
6
7
8
9
FRONT
ALTINEX, INC.
MODEL NUMBERS:
PNP515
3. CUT
Document p/n:
250-0858-003
Page 1 of 4
4"
10
3. CUT
Advertisement
Table of Contents
Related Manuals for Altinex POP 'N PLUG PNP517
Summary of Contents for Altinex POP 'N PLUG PNP517
- Page 1 THIS PORTION. THIS IS TOP COVER. FINISHED CUT-OUT DIMENSION FRONT FRONT DO NOT SCALE OR ADJUST! ALTINEX, INC. ALTINEX, INC. IS NOT RESPONSIBLE MODEL NUMBERS: FOR ANY DAMAGE TO A TABLE OR DESK. PNP515 1. STOP 2. MEASURE 3. CUT...
- Page 2 250-0858-003 Page 2 of 4 Once the initial cut-out has been made to the table, use metal template provided by Altinex to find the location of the pilot holes. Mark the location with a fine marker or pen. Pre-drill pilot holes 10 times in the marked...
- Page 3 Use provided 1/2" screws to mount the wooden cover to the top cover panel. Then make sure the unit is up and secure the top cover to the unit using under-cut screws provided by Altinex. Document p/n: 250-0858-003 Page 3 of 4...
- Page 4 Document p/n: 250-0858-003 Page 4 of 4 To adjust and align the unit to the surface of the table, simply: 1. Close the unit. 2. Loosen all four wing nuts under the table. 3. Press the unit down or upwards from below the desk until it aligns with the surface of the desk.
Need help?
Do you have a question about the POP 'N PLUG PNP517 and is the answer not in the manual?
Questions and answers