Altinex UT240-600 User Manual

UT240-600
Welcome!
Everyone at Altinex greatly appreciates your UT240-600
purchase. We are confident you will find it to be reliable and easy
to use. If you need support, do not hesitate to call at
714-990-2300.
We are committed to developing unique, state of the art Signal
Management Solutions ® for demanding audiovisual installations.
Welcome to Altinex's family of satisfied customers worldwide!

1. Precautions and Safety Warnings

Please read this manual carefully before using your
UT240-600 Power +AV distribution plate, 1U. Keep this
manual handy for future reference. These safety
instructions are to ensure the long life of your UT240-
600 and to prevent fire and shock hazards. Please read
them carefully and heed all warnings.

1.1 General


Qualified Altinex service personnel or their authorized
representatives must perform all service.

1.2 Installation


Place in a dry area away from dust and moisture.

To prevent fire or shock, do not expose unit to water or
moisture. Do not place in direct sunlight, near heaters or
heat-radiating appliances, or near any liquid. Exposure to
direct sunlight, smoke, or steam can harm internal
components.

Handle carefully; dropping or jarring can damage the unit.

Do not pull any cables that are attached to the UT240-600.

Install all cables according with the instructions.

2. Installation Procedures

The UT240-600 is 1U high plate for use in 19" wide mounting rack, multimedia podium, wall-mount rack, etc.
Step 1. Locate position for the UT240-600, but do NOT install until cables are ready.
Step 2. Prepare cables/connectors for ports using high-quality components for
best results and durability. Make cables long enough to allow for service
and routing. Do NOT allow cables to just hang from the UT240.
Step 3. For XLR connectors/cables, remove keystone adapters
installed in the port openings by removing M3 nuts and
screws (two each) from the back of the plate.
Step 4. For USB charging ports, install the dual USB charger
provided with the unit into the rear AC socket. Connect
the two USB cables provided to the USB 2.0 couplers
installed in the plate.
Step 5. Secure the unit to the mounting rack using the four screws and
four washers provided with the unit.
Step 6. Make any necessary connections to the ports.
Step 7. Connect the unit's power cable to a power outlet.
Step 8. Use custom labels by writing name and applying it into recess above required port if needed.

3. Limited Warranty/Return Policies

Please visit the Altinex website at
400-0832-001
Power + AV Distribution Plate, 1U
www.altinex.com for details on warranty and return policies.

1.3 Cleaning


Clean surfaces with a dry cloth. Never use strong
detergents or solvents such as alcohol or thinner. Do not
use a wet cloth or water to clean the unit.

1.4 FCC Notice


This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.

This equipment has been tested and found to comply with
the limits for a Class A digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency
energy and if not installed and used in accordance with
instructions found herein, may cause harmful interference to
radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in
which case the user will be required to correct the
interference at his own expense.

Any changes or modifications to the unit not expressly
approved by Altinex, Inc. could void the user's authority to
operate the equipment.
1
User's Guide