Zanussi ZCAN38EW1 User Manual page 61

Problem
The lid is difficult to open.
The lamp does not work.
The compressor operates con-
tinually.
There is too much frost and ice.
The compressor does not start
immediately after pressing the
SUPER, or after changing the
temperature.
The temperature in the appli-
ance is too low/too high.
Possible cause
There is too much frost in the
appliance.
The lid gasket is dirty or sticky.
The lamp is defective.
Temperature is set incorrectly.
Large quantities of food to be
frozen were inserted at the
same time.
The room temperature is too
high.
Food placed in the appliance
was too warm.
The lid is not closed properly.
The SUPER function is switch-
ed on.
The lid is not closed properly or
the gasket is deformed/dirty.
Temperature is set incorrectly.
This is normal, no error has oc-
curred.
The temperature regulator is
not set correctly.
The lid is not closed properly.
The products' temperature is
too high.
Solution
Defrost the appliance. Refer to
"Care and cleaning/Defrosting
the appliance" chapter.
Clean the lid gasket.
Contact the Authorised Serv-
ice Center to replace the LED
light.
Refer to "Control panel/
Temperature regulation" chap-
ter.
Wait a few hours and then
check the temperature again.
Refer to the climate class chart
on the rating plate or to the
"Installation/Positioning" chap-
ter.
Allow food to cool to room
temperature before storing.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Refer to "Control panel/SU-
PER function" chapter.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Refer to "Control panel/
Temperature regulation" chap-
ter.
The compressor starts after a
period of time.
Set a higher/lower tempera-
ture.
Check if the lid closes properly
and the gaskets are not dam-
aged or dirty.
Allow food to cool to room
temperature before storing.
61