Daewoo KOR-164H0A Service Manual page 13

4. Method to reduce the gap between the door seal and the oven front surface.
1) To reduce gap located on part "A".
Loosen two screws on stopper hinge top, and then
push the door to contact the door seal to oven front
surface.
Tighten two screws.
2) To reduce gap located on part "B".
Loosen two screws on stopper hinge under, and
then push the door to contact the door seal to oven
front surface.
Tighten two screws.
3) To reduce gap located on part "C".
Loosen a screw on interlock switch assembly located top of oven body.
Draw the interlock switch assembly inward as possible to engage with hook on the door bottom.
Tighten a screw.
4) To reduce gap located on part "D".
Loosen a screw on interlock switch assembly located bottom of oven body.
and (4) are same as step (3).
NOTE :
A small gap may be acceptable if the microwave leakage does not exceed 4mW/cm
12
M/W DEF TIMER LOCK Ib
FRESH
BEVERAGE POPCORN
VEGETABLE
FROZEN FROZEN DINNER
VEGETABLE PIZZA PLATE
MORE LESS
MEAT POULTRY FISH
POWER DEFROST
1 2 3
4 5 6
7 8 9
KICHEN
0 CLOCK
TIMER
STOP/CLEAR START
/SPEEDY COOK
2 .