Eco CP-404 Manual page 5

Submersible water pump
ASSEMBLY
Mounting the pressure line see Fig. A
1. Screw the connection elbow (7) into the pump outlet.
2. Screw the combination nipple (5) into the connection elbow.
3. Fix a hose to the combination nipple.
The combination nipple can be trimmed to suit the selected hose connection. Use the largest
possible hose diameter.
STARTUP
Safety
CAUTION!
Exclude, by suitable means that, in the event of a fault in the immersion pump, consequential
damage is caused by flooding.
■
Make sure that the immersion pump is standing securely or operate the immersion pump suspended
from a rope.
■
Make sure there is adequate clearance under the pump.
■
Never allow the immersion pump to run against a closed off pressure line.
■
When using in shafts, make sure the size is adequate.
■
Always cover the shaft with a secure foot-plate.
Switching the pump on
see Fig. A
CAUTION!
The immersion pump must not draw in any solid bodies. Sand and other abrasive materials in the
conveying medium will destroy the immersion pump.
1. Unwind the connection cable (2) completely.
2. Make sure that the electrical plug connection is mounted in the area safe from flooding.
3. Change the terminal position and adjust the switching points of the float switch (3) individually.
4. Attach the cable on the float switch to the pump housing securely.
Recommended cable length on the float switch approx. 120 mm
Use a suitable plate to ensure se-cure mounting of the immersion pump on muddy, sandy or stony
ground.
5. Immerse the immersion pump in the conveying medium slowly. Hold the immersion pump at a slight
angle to allow any air to escape.
6. Insert the mains plug into the plug socket.
The immersion pump switches on automatically using the float switch when a specific water level has
been reached, and switches off again if the water drops below the switch-off height.
Switching the pump off
1 Remove the mains plug from the plug socket.
Pumping out to residual water level
5