Philips 40PFL7664H/12 Service Manual page 30

EN 30 5. Q548.1E LB Service Modes, Error Codes, and Fault Finding
Set is st art in g u p in F act o ry m o d e
Set is starting up in F actory m ode?
Noisy picture with bands/lines is visible and the An "F" is displayed and the HDMI 1
RED LED is continuous on. input is displayed.
- Press the "volume minus" button on the TVs local keyboard for 10
seconds
- Press the "SOURCE" button for 10 seconds until the "F" disappears
from the screen or the noise on the screen is replaced by "blue mute"
The noise on the screen is replaced
with the blue mute or the "F" is disappeared!
Unplug the mainscord to verify the correct
disabling of the factory-mode.
Program display option code
via "062598 MENU", followed by
the 3 digits code of the display
(this code can be found
on a sticker inside the set).
After entering "display option" code, the set is
going in stand-by mode (= validation of code)
R estart the set
H_16771_007b.eps
091119
Figure 5-12 SSB replacement flowchart - set starting up in Factory Mode
2009-Dec-18