Philips 32PFL5405H/05 Service Manual
Chassis q552.1e la
Hide thumbs
Also See for 32PFL5405H/05:
- Quick manual (3 pages) ,
- User manual (65 pages) ,
- Specifications (3 pages)
Table of Contents
Advertisement
Colour Television
Contents
©
Copyright 2010 Koninklijke Philips Electronics N.V.
All rights reserved. No part of this publication may be reproduced, stored in a
retrieval system or transmitted, in any form or by any means, electronic, mechanical,
photocopying, or otherwise without the prior permission of Philips.
Published by ER/TY 1062 BU TV Consumer Care, the Netherlands
Page
Contents
2
6
10
41
47
60
77
78
79
80
81
82
83
84
85
Rembrandt 32"
86
Drawing PWB
87
94
89
94
90
94
92
94
95
102
97
102
98
102
100
102
103
114
123
131
136
137
Chassis
Q552.1E
Page
138
142
146
147
149
150
151
155
159
160
161
167
173
175
177
179
181
182
183
184
Subject to modification
EN 3122 785 18770
LA
18770_000_100210.eps
100210
Advertisement
Table of Contents
Need help?
Do you have a question about the 32PFL5405H/05 and is the answer not in the manual?
Questions and answers
42PFL5405H/12 The TV won't turn on! I changed the batteries in the remote control -> no effect. I opened the back cover of the TV and changed the fuse - T3.15AH250VP -> when I turned on the TV from the back, the fuse blew immediately. Is there some kind of fault in the power supply and are there repair instructions and spare parts somewhere? I can solder. The new power supply cost somewhere around 55€ and the TV is worth 5€. ;0)
Common power supply issues for the Philips 32PFL5405H/05 TV include:
1. The TV does not switch on – this may be due to the power cable not being securely connected or the power switch at the bottom/back of the TV being off.
2. The standby light blinks red – this may require disconnecting the power cable, waiting for one minute, and reconnecting it.
3. Constant rebooting – this can be caused by internal problems, such as issues with the DDR memory or bootscript reading from the PNX8550 processor.
4. Error 16 (12V) – a power supply issue leading to protection mode (LAYER 1 error =3).
The manual mentions reboot diagnostics using a ComPair interface and Hyperterminal for fault finding, suggesting that repair instructions are available for technical troubleshooting.
This answer is automatically generated