Electrical Adjustment Instructions - Philips 32HFL5763D/F7 Service Manual

ELECTRICAL ADJUSTMENT INSTRUCTIONS

General Note: "CBA" is abbreviation for
"Circuit Board Assembly."
Note: Electrical adjustments are required after
replacing circuit components and certain
mechanical parts. It is important to perform
these adjustments only after all repairs and
replacements have been completed.
Also, do not attempt these adjustments unless
the proper equipment is available.
Test Equipment Required
1. Remote control unit
2. Color Analyzer,
CA-310 (KONICA MINOLTA Luminance meter) or
measuring instrument as good as CA-310.
[32HFL5763D/F7]
How to set up the service mode
How to set up the service mode with
Guest Remote Control Unit
1. Turn the power on.
2. Press [0], [6], [2], [5], [9], [6] and [INFO] buttons on
the remote control unit in this order.
3. Select "Quality" - "BE Factory Mode" and press the
[OK] button. The following screen appears.
" * " differs depending on the models.
Code:
Pic code:
Option code:
MIPS:
Safety:
How to set up the service mode with Set
Up Remote Control Unit (optional)
1. Turn the power on.
2. Press [0], [6], [2], [5], [9], [6] and [RECALL/INFO]
buttons on the set up remote control unit in this
order.
3. Select "Quality" - "BE Factory Mode" and press the
[OK] button. The following screen appears.
" * " differs depending on the models.
Code:
Pic code:
Option code:
MIPS:
Safety:
5-1
*******-**-**-****-**
**********-***-*-**
***-***-***-***
Push 0 key
Press "POWER" key to exit.
Safety_Non Total Watch Time:
Lightsensor:
*******-**-**-****-**
**********-***-*-**
***-***-***-***
Push 0 key
Press "POWER" key to exit.
Safety_Non Total Watch Time:
Lightsensor:
A17FYUH_EA
*****
****
*****
****