Using Detergents Or Fabric Softeners - LG TROMM FR2655NC1Z Instruction Manual

Using Detergents or Fabric
Softeners
Using Detergents
• Use a special drum washer detergent. If you use a
general type product, it can create excessive bubbles.
• Apply the recommended amount of detergent as
indicated by the maker.
• If a specific washing cycle requires a different amount
of detergent, then refer to ʻUsing Washing Cyclesʼ.
• Even if a washer model displays the amount of
detergent required, then you do not need to follow it.
• For Commencer washer, refer to the below table when
you add detergents.
Amount of detergent used by the
Amount
of
laundry
condensation
(drum only)
2.0 - 3.5 kg
2.0 kg or
less
1.0 kg or
less
• The front load washer adopts the waterfall method for
washing, so it only uses 1/3 of the amount of water
required by a general washer. Also, the amount of
detergent required is 1/3.
• If your laundry causes les pollutions, reduce the
amount of detergent. If you use too much, then
excessive bubbles will remain even after rinsing.
• If the water quality is good (sweet water), then it has
great washing power and creates lots of bubbles. So,
reduce the amount of detergent.
• When you use liquid detergents, reduce the amount
used, as it is very well dissolved in water and creates
lots of bubbles.
• Natural soap powder is not very well dissolved in
water, easily causing clogging. If you use it in cold
water, it can cause leakages r malfunctions. Make
sure to use lukewarm water.
24
commencer washer
[g or ml]
High
Powder/liquid
(drum only)
8 13
6 10
5 8
• If you use the pre washing cycle, use less than 1/2 of
the amount of detergent for the main cycle.
• If detergent exists as lumps, then grind it into powder
before use.
NOTE
• Stains on inner wear (cotton) or baby clothes are
mostly fats or proteins. So, instead of using lots
of detergents, it is more effective to wash at high
temperature and increase the number of rinsing
process.
• The water supply time is short, so make sure to add
detergent before washing begins.
• If the washing bucket is wet, then it is likely that some
detergents still remain in it. Make sure to remove
water before using the washer.
• As lint, fabric softeners, or zeolite in laundry is
discharged, the high-speed rotating pump propeller
can create fine bubbles that make the water look
murky. Even if the drained water looks murky, it does
not mean that rinsing is incomplete.
• If you use too much, then excessive bubbles will
remain even after rinsing, causing an increase in the
rinsing time. In addition, you will see some bubbles
even after the final spin-drying process.
Using Fabric Softener
• It is automatically injected at the time of initial rinsing.
• Do not exceed the max line for fabric softener. If not,
fabric softener will be directly injected into the washer.
• Before washing begins, add fabric softener into the
correct location in the washing bucket. Close the
detergent box by osftly pushing it. If not, as fabric
softener fluctuates, it can go directly into the washing
bucket.
CAUTION
• Do not let fabric softener stay in the washing bucket
for more than two days. As it hardens, automatic
injection can fail.
• Do not use condensed fabric softener. Injection can
fail.