Related Manuals for Häfele Connect Mesh
Summary of Contents for Häfele Connect Mesh
- Page 1 Connect Mesh 2 Channel Interface Version 1.0 © 2020 by Häfele GmbH & Co KG Subject to Adolf-Häfele-Str. 1 · D-72202 Nagold www.hafele.com alteration...
-
Page 2: Change History
1. Change history Version Date Changes • Initial Documentation © 2020 by Häfele GmbH & Co KG Subject to Adolf-Häfele-Str. 1 · D-72202 Nagold www.hafele.com alteration... -
Page 3: Table Of Contents
2. Table of Contents 1. Change history _________________________________________________________________________________________________________2 2. Table of Contents _______________________________________________________________________________________________________3 3. Connect Mesh 2 Channel Interface ______________________________________________________________________________________4 3.1. General information _____________________________________________________________________________________________________4 3.2. Setup_________________________________________________________________________________________________________________4 3.3. Switching a group on/off _________________________________________________________________________________________________4 3.4. Dimming ______________________________________________________________________________________________________________4 3.5. Update Mode __________________________________________________________________________________________________________5 3.6. Reset _________________________________________________________________________________________________________________5 3.7. -
Page 4: Connect Mesh 2 Channel Interface
3.4. Dimming If the inputs of the Connect Mesh 2 Channel Interface are added to a device group, you can use it to dim the brightness of the light. By keeping the switch pressed, the light will start getting brighter. Release the switch press at a certain level of light brightness to set it. -
Page 5: Update Mode
Option 1: Update Mode by App • In case the firmware is outdated, the user will be notified inside the Connect Mesh App. There the user can start and perform the update of the mesh device (more information in the specific Häfele Connect Mesh App).