Table of Contents
Advertisement
OPERATION
Float and thermostatic traps have two basic elements: a
thermostat for venting air from the system during start-up
and a float assembly for draining condensate.
The thermostat is normally open. It allows air to vent until it
is within 10-30°F (4-12°C) of the steam temperature.
The float assembly drains condensate from the system
when buoyancy force lifts the float ball and opens the
valve. The weight of the float ball causes the pin to close
against the trap seat when condensate is not present.
!
To prevent serious personal injury from steam
pipe blow down, connect a temporary pipe
between the steam pipe opening and a drain,
or stand at least 100 ft. (30m) from the pipe
opening.
Failure to follow this warning could cause
property damage, personal injury, or death.
INSTALLATION –
Series H, C and X Float and
Thermostatic Steam Traps
STEP 1
1. Determine where to install the trap, based on the
following requirements:
• The trap must be located as close as possible to, and
below the equipment to be drained.
• The trap must be in a straight run of horizontal pipe as
shown in the "Typical Piping Diagrams," and pitched to
allow condensate to flow into trap inlet, and away from
trap outlet.
• Allow for enough space around the trap for servicing,
which may include removal of the body or cover,
depending on the model you are installing.
The Hoffman Series H traps provide an additional opening
where a test valve may be installed. On traps that do not
have an additional opening, the test valve can be installed
in a tee fitting in the discharge line.
2
WARNING
Materials of Construction
Part
Body and Cover
Valve Pin and Seat
Float
Lever Assembly
Thermostatic Air Vent
Cover Bolts
Baffle
INLET
TEST
INLET
OUTLET
T
OUTLET
TEST
Specifications
Cast Iron 30,000 psi tensile
Stainless Steel (Hardened)
Stainless Steel
Stainless Steel
Stainless Steel Cage and
Thermal Element
Grade 5
1
Stainless Steel {2
/
" units only}
2
OUTLET
TEST
INLET
TEST
INLET
OUTLET
Advertisement
Table of Contents
