Delta essentials GT-DR-01 Instruction Manual page 13

Steam cleaning
DANGER
- Never direct the boiling hot steam towards people, animals, plants or delicate
objects.
- Keep device level during operation. Otherwise there is risk of dripping and
burns.
- There is a risk of injury due to glass breaking and scattering of shards in the
event of considerable differences of temperature between glass inside and
outside or between the glass and the silver coating of a mirror. Always spray all
cold surfaces with extreme care and at a certain distance, and heat the steam
gradually.
WARNING
The surface to be cleaned must be solid, resistant to abrasions and sturdy if you
intend to use the brushes. The less resistant surfaces risk to be ruined.
3. Direct the steam onto the place to be cleaned and proceed according to the selected
accessory, refer to page 11.
4. Release the steam button to interrupt the steam jet.
Please note:
Especially after start-up, droplets of water are possible. This is entirely normal.
The light comes on and switches off while the appliance is functioning. This is not a fault,
however it indicates that the steam has been used up, and that it must be generated
again. Normally it is not necessary to stop working.
HELPLINE No. U K / N.IRELAND 0800 328 60 20 REP. IRELAND 00 800 44 67 58 88
WEB SUPPORT info@dariolondon.com
Model Number: GT-DR-01
1. Insert the plug into a wall socket. The steam light
switches on (see the arrow) and the appliance
starts to warm up. The light switches off after a
few minutes, and the appliance is then ready to
be used.
2. Activate the steam button to generate a steam
jet. Keep device level during operation.
- The steam flow increases proportionally to
the duration of usage of the button.
- First of all direct the appliance onto a fabric
until the steam comes out without forming
any water drops.
13