Cetacea Sound Ensemble 90-3 Quick Start Manual

The Ensemble 90 is a professional surround sound system for presentations
to audiences. Its unique ultra light design creates a perfect sound for both voice
and multi-media presentations. This new ENS-90-3 is loud enough for a room of
90 people. Please read this instruction guide thoroughly before attempting to use
this product.
1) There are three (3) source-input plugs on the Ensemble speaker base that
can use either mono or stereo inputs depending on your "source", i.e.,
computer, VCR, DVD, projectors, microphones, etc.
2) The Ensemble does not have an internal volume control. Use the volume
control on your source or, if required, use the in-line volume control
included in this kit. The right angle plug of the volume control must be
plugged into the "source". Use the male-to-male extension cable to finish
the connection to one of the Ensemble inputs labeled A, B, or C. Refer to
the hook-up drawings on our web site if you have further questions.
3) If your source has a "BASS BOOST", or special effects like Spatializer,
SRS, or controls that say "JAZZ", "ROCK", "BLUES", etc., turn them off
for now!
4) Turn the volume down low before making the power connection.
5) The Ensemble speaker requires power from the Cetacea Sound Corp
approved "Power Adapter/Conditioner". Plug the power adapter into a
suitable source of 110-220v power and the opposite small end into the
base of the Ensemble speaker. (It will only fit in one location.)
6) Turn on the source and slowly turn up the volume (on both the source and
the in-line volume control). Be sure to use a high quality recording to fully
appreciate the awesome sound of the speaker. Once you are satisfied
with the sound, add additional sources to the other input jacks so you can
use them without changing connections every time.
Read These insTRucTions closely
Ensemble 90-3
Portable Presentation Speaker
Quick Start Guide
Model #: ENS-90-3
200901-013