Figure 30. Remove the strip cover
Go to
https://support.lenovo.com/partslookup
part:
Strip cover
Remove the LCD module
Make sure the following FRUs (CRUs) have been removed.
"Remove the lower case" on page 28
"Remove the thermal module" on page 38
"Remove the strip cover" on page 42
Step 1.
Peel off the tape securing the EDP cable. Disconnect the EDP cable from the system board.
Figure 31. Disconnect the EDP cable
Step 2.
Remove two screws.
44
Hardware Maintenance Manual
to look up the Lenovo part number of the following replacement