FoamPRO 3012 Installation And Operation Manual

Download this manual

All quality FoamPro products are ruggedly designed, accurately machined, carefully assembled, thoroughly inspected

and tested. In order to maintain the high quality of your unit, and to keep it in a ready condition, it is important to follow the

instructions on care and operation. Proper use and good preventive maintenance will lengthen the life of your unit.

ALWAYS INCLUDE THE UNIT SERIAL NUMBER IN CORRESPONDENCE.

FoamPro • 375 Fifth Avenue NW • New Brighton, MN 55112 USA • (651) 766-6300 • FAX (651) 766-6614

Manual Override

INSTALLATION AND

OPERATION MANUAL

3012

Unit

Serial

Number

Form L-0933

7/11

Need help?

Do you have a question about the 3012 and is the answer not in the manual?

Page 1 Proper use and good preventive maintenance will lengthen the life of your unit. ALWAYS INCLUDE THE UNIT SERIAL NUMBER IN CORRESPONDENCE. FoamPro • 375 Fifth Avenue NW • New Brighton, MN 55112 USA • (651) 766-6300 • FAX (651) 766-6614...
Page 2 The master Auto/Manual Switch should be Since this mode of operation is outside of normal located within one foot of the FoamPro 3012 foam pump. procedures, location of the Manual Pump Control away Do not extend the hydraulic control valve cable. A Manual from standard foam controls is recommended.
Page 3 If the 3012 was running when the switch was rotated, it will continue to run until the switch is placed in Auto mode, or if the switch is placed in Manual mode and the 3012 toggle switch is held in the Decrease position for several seconds.
Page 4 Styrofoam and other packaging materials, as it was received at your facility. FoamPro appreciates your attention in this matter, as we feel it will help us to serve you in a better fashion, while keeping the cost of the FoamPro product competitive.