Advertisement
UNPACKING AND INSPECTION:
Carefully lift your Heavy Duty Electric Solid Hot Plate out of shipping container, and inspect immediately for
shipping damage. Install 4-inch legs as follows: Remove the legs from plastic shipping bag, turn your Heavy Duty
Electric Solid Hot Plate on its side and screw legs into the four holes provided in bottom.
NOTE: Your Heavy Duty Electric Solid Hot Plate was shipped in a carton designed to give it maximum protection
in normal handling. It was thoroughly inspected before leaving the factory and the carrier accepted and signed for it.
File any claims for shipping damage or irregularities directly with the carrier, not with company.
ELECTRICAL HOOKUP:
Insert Line Cord Plug into appropriate NEMA Receptacle as specified.
NOTE: A separate circuit should be supplied for each of these
Check local codes for compliance in installation.
WARNING: WARRANTY IS VOID IF HOT PLATE IS CONNECTED TO ANY VOLTAGE OTHER THAN THAT SPECIFIED.
WARNING: INSTALL HOT PLATE AT LEAST 1" FROM WALL. DO NOT OPERATE HOT PLATE UNLESS LEGS ARE
INSTALLED.
Hot Plate
Before using
for the first time, heat up elements for three to five minutes to burn off protective coating. This
also hardens the surface of the solid heating elements.
The solid heating elements are easily cleaned with a damp cloth after use. Clean up dirt and spills with Ajax and a
Scotchbrite pad. After cleaning, rub a few drops of cooking oil into the surface of the elements; then switch on for a
few minutes to re-harden.
Use Ajax and a Scotchbrite pad to keep the exterior surfaces of your short order
rubbing with the grain of the stainless steel. Rinse and wipe dry; then polish with a soft cloth.
These simple procedures will keep your short order
you many years of service.
A circuit diagram has been provided to assist qualified technicians. A Recommended
Qualified Service Technician should carry out repairs if needed. Do not remove any
components or service panels on this product.
** CLEANING INSTRUCTIONS **
Hot Plate
Hot Plate
with a matched circuit breaker or fuse.
Hot Plate
clean and sparkling. A well cleaned
Hot Plate
free of dirt and blemishes,
Hot Plate
will give
Advertisement
