Olsen Lab Chair Quick Operation Manual

Lab Chair Quick Operation Guide - Description of Parts and Controls of Equipment
Before using the equipment, please read the User Manual Lab Chair carefully.
Athe purpose of this guide is to identify commands, parts, and instruments that may be available to the equipment, including optional items.
This guide does not define the equipment configuration that may vary according to the customer's request.
In case of loss of the user manual contact us by e-mail
Turning On the Equipment :
2
1 - On/Off Switch with LED
2 - Fuse Holder
1
F01
1º - To turn On the equipment press the On/Off switch (F01-1) to
the "I" position;
2º - The LED on the On/Off switch (F01-1) will turn green,
indicating that the equipment is ready for use;
3º - To turn Off the equipment press the On/Off switch (F01-1) to
the "O" position.
Seat Up
1
1 - Plastic Knob
1º - To adjust the height and distance from the seat, turn the
plastic knob (F03-1) counterclockwise to loosen;
2º - To lock the accessory position, turn the plastic knob (F03-1)
clockwise.
Observe the Scheduled Review system for your equipment Chapter 15 of the User Manual Lab Chair.
export3@olsen.odo.br
1º - To install the leg rest set, turn the handle knob on the
bracket locks (F03-1), attach the metal support (F04-3),
and then tighten the handle knob again (F03-1);
Backrest Up
2º - To engage the leg rest (F04-1), turn the handle
knob (F04-2) and attach the leg rest (F04-1) to the metal
support (F04-3). Tighten the handle knob (F04-2) to
secure the supports (F04-1);
Seat Down
3º - To align the leg rest (F04-1), turn it on the shaft (F06),
for better adaptation to the patient.
Backrest Down
F02
F03
informing the serial number of your equipment.
1
4
F05
2
3
F04 F06
1 - Leg Rest
2 - Plastic Knob
3 - Metal Support
4 - Fixing Points
2
1
Adjust the heel support (F10-1) according to the patient profile or
procedure to be performed.
1º - To adjust the distance of the heel support (F10-1) simply fit it
into the hole (F10-3) corresponding to the desired distance.
3
F10
1 - Heel Support
2 - Metal Support
3 - Adjustment Holes
1
4
2
2
3
3
F07 F08 F09
1 - Articulated Headrest
2 - Handle Knob
3 - Adjustment Bar
4 - Multiarticulated Headrest
5 - Position for Wheelchair Patients
1º - To adjust the position of the headrest (F7-1/F08-4) turn the
handle knob (F07-2/F08-2) counterclockwise to loosen it and then
adjust it to the desired position. Turn the handle knob (
clockwise to lock in the set position;
2º - To adjust the height of the headrest ( F7-1/F08-4
bar ( F7-3/F08-3 ) until you reach the position. The headrest
bar ( F7-3/F08-3 ) allows adjustment with up to 17 cm from the
backrest.
- Equipments made to last!
5
F07-2/F08-2 )
) move the
Page 01 - 5409202 - R00