iRobot H1 Owner's Manual page 6

Using Your Handheld Vacuum
Note: For household indoor use only.
Charging
• Insert the charger into the charging port of your handheld vacuum.
The LED light will flash blue when charging. Once fully charged, the
LED light will turn off.
Note:
The vacuum requires up to 4 hours to be fully charged.
• The LED light will flash red when your handheld vacuum is low
on battery.
• It is recommended to charge your vacuum after each use to
maintain maximum performance.
Note: As a safety precaution, the vacuum cannot be switched on
while charging.
Storage
Your handheld vacuum can be wall-mounted using the wall mount
bracket, drywall anchors, and screws provided.
When selecting a location, ensure there are no utility/service lines
(electrical wiring, water supply, gas supply, air, etc.) located directly
behind the mounting location. Mount the bracket in accordance with
all applicable codes and requirements. The use of personal protective
equipment, such as safety glasses and gloves, is recommended.
1
Using the wall mount bracket as a template, mark the location of
the screw holes.
Caution: Do not mount the bracket at a height greater than 3 feet (1 meter)
from the floor.
2
Using a 5/16 inch (8mm) drill bit, drill two pilot holes and insert the
drywall anchors into the pilot holes.
Note: If mounting directly onto a wall stud, it is not necessary to install the
drywall anchors. Use the screws to secure the bracket onto the wall stud.
3
Install the screws and bracket until
the wall mount is held firmly in
place. Do not over tighten.
Handheld Vacuum H1 Owner's Guide
EN
2