Ea-100 Setup - Casio E-CON Software Manual

2. EA-100 Setup

You can use the E-CON Mode to set up the EA-100 for sampling and then start sampling
immediately or save the setup in calculator memory. You can use either of the following two
methods to set up the EA-100.
Setup Wizard:
Advanced Setup: Advanced setup gives you control over a variety of sampling
k Using Setup Wizard to Create an EA-100 Setup
With Setup Wizard, you set up the EA-100 simply by replying to questions as they appear.
u Setup Wizard parameters
Setup Wizard lets you make changes to the following three EA-100 basic sampling
parameters using an interactive wizard format.
• Sensor (Select Sensor)
Specify a CASIO or VERNIER*
• Sampling Interval (Sampling Time)
When you have Photogate specified as the sensor type, you can specify the sampling
timing (Gate Status) and sampling time recording method (Record Time) with this
parameter.
• Number of Samples (Number of Samples)
You can specify a value from 1 to 255.
Note the following limitations that apply to a setup made using Setup Wizard.
• You can use Setup Wizard only when the EA-100 sampling channel is CH1 or SONIC.
• The trigger for a Setup Wizard setup is always the w key.
• Sampling results are always stored in List 1 (for the sampling time) and List 2 (for
sample values).
1
* Vernier Software & Technology
2-1
EA-100 Setup
With this method, you set up the EA-100 simply by replying to
questions as they appear.
parameters, which means you can set up the EA-100 for exactly the
type of sampling you want.
1
sensor from a menu of choices.