MSI Z68A-G43 Series Manual page 41

MS-7750 Manboard
▶ tRFC
Ths settng determnes the tme RFC takes to read from and wrte to a memory
cell.
▶ tWR
Determnes mnmum tme nterval between end of wrte data burst and the start of a
pre-charge command. Allows sense amplfiers to restore data to cell.
▶ tWTR
Determnes mnmum tme nterval between the end of wrte data burst and the start
of a column-read command; allows I/O gatng to overdrve sense amplfiers before
read command starts.
▶ tRRD
Specfies the actve-to-actve delay of dfferent banks.
▶ tRTP
Tme nterval between a read and a precharge command.
▶ tFAW
Ths tem s used to set the tFAW (four actvate wndow delay) tmng.
▶ tWCL
Ths tem s used to set the tWCL (Wrte CAS Latency) tmng.
▶ tCKE
Ths tem s used to set the Pulse Wdth for DRAM module.
▶ tRTL
Ths tem s used to set Round Trp Latency settngs.
▶ Advanced Channel 1/ 2 Tmng Configuraton
Press <Enter> to enter the sub-menu. And you can set the advanced memory tmng
for each channel.
▶ GT OverClockng
Ths tem allows you to enable/ dsable the overclockng of ntegrated graphcs.
▶ GT Rato
Ths settng controls the rato of ntegrated graphcs frequency to enable the ntegrated
graphcs to run at dfferent frequency combnatons.
▶ Adjusted GT Frequency
It shows the adjusted ntegrated graphcs frequency. Read-only.
▶ Spread Spectrum
Ths functon reduces the EMI (Electromagnetc Interference) generated by modulatng
clock generator pulses.
Important
• If you do not have any EMI problem, leave the settng at [Dsabled] for optmal system
stablty and performance. But f you are plagued by EMI, select the value of Spread
Spectrum for EMI reducton.
En-30