Advertisement
Motor does not start
E1 displayed on the screen
Motor runs, but the heater does not ignite and
locks out after a short time
E1 displayed on the screen
Heater starts but combustion is not good
Heater stops during operation
Ambient temperature displayed on the screen
Heater stops during operation
E1 displayed on the screen
Heater stops during operation
E3 displayed on the screen
L0 displayed on the screen
Motor does not start
Hi displayed on the screen
EP/EC displayed on the screen
WEEE REGULATIONS
Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment
(WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid
waste authority for recycling information.
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500
© Jack Sealey Limited
No power or low voltage
Faulty or damaged power cord
Faulty motor/capacitor
Lock-out of appliance due to previous
overheating
The temperature probe is faulty or the
connector for temperature probe is loose
Empty fuel tank, dirty or wrong fuel
Ignition fault, dirty or incorrect electrodes
position
Fuel filter clogged
Burner nozzle clogged
Fuel viscosity increased at low temperature
The room temperature set on room
thermostat has been reached
Flame failure
Bad combustion
Reduced airflow
Overheating
Internal generator overheating
Wrong fuel pressure
Anti-tilting sensor inverted
Low temperature display, The ambient
temperature is below -9°C
High temperature display ,The ambient
temperature is greater than 65°C
PCB Communication failure or Control circuit
damage
01284 703534
sales@sealey.co.uk
Original Language Version
Check power line and voltage
Check fuse located behind control panel and
replace if necessary
Check and replace if needed
Check and if necessary replace
Detect the cause of overheating
Shut the appliance down
Check air inlet and outlet
Wait some minutes and restart the appliance
Check and replace the temperature probe if
needed
Check and replace the PCB if needed
Remove wrong or dirty fuel
Fill the tank with clean Diesel or kerosene
Check and clean electrodes
Clean or replace fuel filter
Clean nozzle blowing compressed air, replace
if necessary
Mix Diesel with 10-20% Kerosene
Normal operation
To start turn the temperature control knob
clockwise on a higher setting
Check and remove the cause(s) of
malfunction
To reset, turn On/Off switch to 0 and then to I
Call technical service if the problem persists
Turn the generator off, wait until it is cooled
down
Contact your local authorised service agent
for repair
Replace the heater on a level and stable
surface
Normal operation of products
Place at low ambient temperature
Replace the PCB
www.sealey.co.uk
AB3412 Issue 2 (3) 03/02/2021
Advertisement
